Hi, All,
I have two USB3 host add in cards, which is PCIe interface.
So I install one on the host PC, and the other on the target PC for Windbg debugging.
But I don’t know what to do to make a usable cable for this dbg.
I hope the cable change is not complicated and no too much cost.
What I consider is use two USB3 cable, cut the device end, and connect the two host end, without vbus.
Does any one previously use USB3 debugging?
Actually, I have bought two USB2 debug cable/equipment, each is about 100$, but does not take effect, as USB2 debugging’s requirement is more complicated than USB3.
So these two USB2 debug equipment is leave as gabbage in the corner of lab.