Hi all,
When I debugged an executable program, the executable module name is mistakenly displayed with an nonexistent module name each time, however, the module name will be CORRECTLY displayed after I use the command .reload /s to reload these symbols. I don’t know what’s going on at all.
Also, I don’t found other .exes exist this problem.
If someone know the reasons, please tell me know . thanks.
-Matt
I’m not entirely sure what you’re describing, but having to use ‘.reload’ is
not at all unusual.
Good luck,
mm
From: xxxxx@lists.osr.com
[mailto:xxxxx@lists.osr.com] On Behalf Of zMatthew
Sent: Friday, December 17, 2010 1:48 AM
To: Kernel Debugging Interest List
Subject: [windbg] The .exe module name can’t be correctly displayed with lm
command
Hi all,
When I debugged an executable program, the executable module name is
mistakenly displayed with an nonexistent module name each time, however, the
module name will be CORRECTLY displayed after I use the command .reload /s
to reload these symbols. I don’t know what’s going on at all.
Also, I don’t found other .exes exist this problem.
If someone know the reasons, please tell me know . thanks.
-Matt
WINDBG is sponsored by OSR
For our schedule of WDF, WDM, debugging and other seminars visit:
http://www.osr.com/seminars
To unsubscribe, visit the List Server section of OSR Online at
http://www.osronline.com/page.cfm?name=ListServer