Hi,
How do you debug a system going on to standby state? Is this possible in
softice by setting a breakpoint in the PowerDispatch function as essentially
an IRP_MN_QUERY_DEVICE is the one that comes down first? In effect, what I
want to do is to send a specific command before the system goes into
standby. Where do I put this particular command and then the system proceeds
as usual to go into standby.
Thank you,
Anne
=================================
Anne Elizabeth Philip
TDK Systems Europe
126 Colindale Avenue
London. NW9 5HD
Tel: +44(0)208 938 1014
Fax: +44(0)208 905 8608
WWW:http://www.tdksys.com
email:xxxxx@tdksys.com
TDK
at the heart of it
You are currently subscribed to ntdev as: $subst(‘Recip.EmailAddr’)
To unsubscribe send a blank email to leave-ntdev-$subst(‘Recip.MemberIDChar’)@lists.osr.com
Please read the DDK power management design guide. It’s all explained very
clearly.
-----Original Message-----
From: Anne Philip [mailto:xxxxx@tdksys.com]
Sent: Friday, February 23, 2001 3:39 AM
To: NT Developers Interest List
Subject: [ntdev] Standby question
Hi,
How do you debug a system going on to standby state? Is this possible in
softice by setting a breakpoint in the PowerDispatch function as essentially
an IRP_MN_QUERY_DEVICE is the one that comes down first? In effect, what I
want to do is to send a specific command before the system goes into
standby. Where do I put this particular command and then the system proceeds
as usual to go into standby.
Thank you,
Anne
=================================
Anne Elizabeth Philip
TDK Systems Europe
126 Colindale Avenue
London. NW9 5HD
Tel: +44(0)208 938 1014
Fax: +44(0)208 905 8608
WWW:http://www.tdksys.com
email:xxxxx@tdksys.com
TDK
at the heart of it
You are currently subscribed to ntdev as: xxxxx@microsoft.com
To unsubscribe send a blank email to leave-ntdev-$subst(‘Recip.MemberIDChar’)@lists.osr.com
You are currently subscribed to ntdev as: $subst(‘Recip.EmailAddr’)
To unsubscribe send a blank email to leave-ntdev-$subst(‘Recip.MemberIDChar’)@lists.osr.com