RE: W2000 Checked Build Crash during Setup on Intel A15 C-hipSet-based Motherboard

Have you checked with Dell? I know that going between 98 (which is what the
4100 is pre-loaded), and NT you may need to make some “patches” to the BIOS.
One of our engineers here spent several hours on the phone with a Dell
technician making those changes so he could load 98 over NT.

-----Original Message-----
From: Fatih Comlekoglu [mailto:xxxxx@mavion.com]
Sent: Monday, August 21, 2000 12:58 PM
To: NT Developers Interest List
Subject: [ntdev] W2000 Checked Build Crash during
Setup on Intel A15 ChipSet-based Motherboard

I just received Dell 4100 series system w/ 256 M RAM that is
based on
Intell’s the latest A15 chip set. When I installed Win2000,
after Win2000
started to run, I needed to install some drivers for the
chip set (I think)
to eliminate an error in the NT event log.

Win 2000 installed and running w/o a problem. But when I
tried to install
Win2000 checked buuild, after the re-boot, the setup
continues. the system
loads the drivers and starts loading Win2000. Right there
the system
receives BSOD. the BSOD is:
STOP: 0x0000001E
KMODE_EXCEPTION_NOT_HANDLED in ntoskrnl.exe

My question is did anyone experience with loading checked
build of Win2000?
Are there any remedies? Are there any ways to install
HAL-like drivers to
resolve this problem during W2K Load. Again, the chip set is
the latest by
Intel A15 (uses P133 SDRAM).

Thanks for any input,

-Fatih


You are currently subscribed to ntdev as:
xxxxx@delphieng.com
To unsubscribe send a blank email to
$subst(‘Email.Unsub’)