Mark,
Thanks for the reply.
I went to the Hollis Tech website and found the article you wrote. Can I do
it from my notify object (user mode)?
John
-----Original Message-----
From: Roddy, Mark [mailto:xxxxx@stratus.com]
Sent: Friday, February 02, 2001 10:44 AM
To: NT Developers Interest List
Subject: [ntdev] RE: Please help! Trying to get bus and slot of device
in notify obje ct…
Try the resources page of my web site. I think there is a knowledge base
article at Microsoft that also covers this issue.
Mark Roddy
xxxxx@hollistech.com
www.hollistech.com
WindowsNT Windows 2000 Consulting Services
-----Original Message-----
From: John Hirschi [mailto:xxxxx@SonicWALL.com]
Sent: Friday, February 02, 2001 11:39 AM
To: NT Developers Interest List
Subject: [ntdev] Please help! Trying to get bus and slot of device in
notify obje ct…I’ve asked this question twice, with no response. If you even have a
suggestion of where to start looking, please reply and tell
me where I can
start. I’ve waded through the DDK and read everything that
looked relevant,
with no luck. Anyone?Using the INetCfg interface, I got an enumeration of all of
the network
devices on the system. Going through this list and sending
each device’s
DevNodeID to the CM_Locate_DevNode function, I’ve been able
to identify
which devices are currently installed. Now that I know which
devices are
currently installed, I want to know the PCI bus number, slot
number, and
function of these currently installed devices.I am writing a notify object for my intermediate driver
(using the sfilter
and passthru ddk examples). Can someone please point me in the right
direction?Thanks,
John Hirschi
You are currently subscribed to ntdev as: xxxxx@stratus.com
To unsubscribe send a blank email to leave-ntdev-$subst(‘Recip.MemberIDChar’)@lists.osr.com
You are currently subscribed to ntdev as: xxxxx@sonicwall.com
To unsubscribe send a blank email to leave-ntdev-$subst(‘Recip.MemberIDChar’)@lists.osr.com
You are currently subscribed to ntdev as: $subst(‘Recip.EmailAddr’)
To unsubscribe send a blank email to leave-ntdev-$subst(‘Recip.MemberIDChar’)@lists.osr.com