Hi,
is you guess i’m new in this driver development topic. As i see its (or
looks like) a difficult job to make a running driver.
Right know i’m on the way developing a nic driver running on the pcimcia
bus. If not wrong doing this using NDIS will simplify (hope so) the job. Any
suggestions, warnings source etc. would be helpful.
My special question is, do my miniport driver needs a flow control
mechanism? I mean, how do a say the nic I will transfer YYY (say 100) bytes.
The card i’ m working on has I/O space with 16 bit Tx/Rx buffers. Does this
mean the 100 bytes should be sent in 16 bit fragments?
If this is the case how does the card knows the whole data is 100 bytes
long, since it should reassemble the 16 bit data to make a single 100 byte
packet.
I’ m not sure about having the question stated correctly. My good i’m so
confused. Thanks in advance.
Best Regards
Yagmur Konuslu
######################################################################
Dikkat:
Bu elektronik posta mesaji kisisel ve ozeldir. Eger size
gonderilmediyse lutfen gondericiyi bilgilendirip mesaji siliniz.
Firmamiza gelen ve giden mesajlar virus taramasindan gecirilmekte,
guvenlik nedeni ile kontrol edilerek saklanmaktadir. Mesajdaki
gorusler ve bakis acisi gondericiye ait olup Aselsan A.S. resmi
gorusu olmak zorunda degildir.
######################################################################
Attention:
This e-mail message is privileged and confidential. If you are
not the intended recipient please delete the message and notify
the sender. E-mails to and from the company are monitored for
operational reasons and in accordance with lawful business practices.
Any views or opinions presented are solely those of the author and
do not necessarily represent the views of the company.
######################################################################