The USB 3.0 Insertion Test should verify that a USB 3.0 device always connects on the SuperSpeed port.
The test works with USB 3 devices!
If run the test for a high speed or full speed USB 2 device the test fails with following error:
A device has connected to USB2 port 8. Port status 0x101 change 0x1.
The test works with earlier HLK 22H2 and 22H1.
For my opinion the test should not be run for devices with high, full or low speed. Earlier HLK don’t bring a prompt to reconnect the device. It sems that the test is skipped for USB2 devices. There must be a change in HLK because I use the same computer hardware and the same devices.
Last filter updates and playlists are loaded.
Has anybody an idea what can be done to pass the test?