Hello All,
I am running Crash N Node to validate our multipath solution. However the
test results are not very consistent. Sometimes the crash n node passes,
while sometimes it fails for the exact same setup (same driver, disk time
out, storage backend). Following are the error messages that I get;
Any help in this regard will be highly appreciated.
CD8.0EC8 2005/02/24-01:26:52.703 +VAR+INFO 8 : [HCT]STATUS BAR - Running
tests
0CD8.0EC8 2005/02/24-01:26:52.703 +VAR+INFO 8 : [WTT]MiscThread Leaving
“StartingTestThread” dwRet: 0
0CD8.0D5C 2005/02/24-01:28:03.078 +VAR+WARN 8 : [HCT]Status=2(2H) spfail.exe
(pid=3908) on XXXX has stopped (ran for 1 mins, minimum runtime is 410
mins)(valdkit.cpp@5175)
0CD8.0D5C 2005/02/24-01:28:10.078 +VAR+SEV2 9 : [HCT]Status=6(6H) A critical
process: spfail.exe (pid=3908) has stopped on DEBUGGEE2.(valdkit.cpp@4623)
0CD8.0D5C 2005/02/24-01:30:33.750 +VAR+SEV2 10 : [HCT]Status=1805(70DH)
ClockThread - Error verifying list (valdkit.cpp@4005)
0CD8.0A88 2005/02/24-01:32:38.625 +VAR+INFO 11 : [WTT]Elements of
StrResConfigScriptRun
0CD8.0A88 2005/02/24-01:32:38.640 +VAR+INFO 11 :
[WTT]------------------------------
0CD8.0A88 2005/02/24-01:32:38.640 +VAR+INFO 11 : [WTT]
0CD8.0A88 2005/02/24-01:32:38.640 +VAR+INFO 11 : [WTT]Elements of
StrResCleanupScriptRun
0CD8.0A88 2005/02/24-01:32:38.656 +VAR+INFO 11 :
[WTT]------------------------------
0CD8.0A88 2005/02/24-01:32:38.656 +VAR+INFO 11 : [WTT]
0CD8.0A88 2005/02/24-01:32:38.671 +VAR+INFO 11 : [HCT]
0CD8.0A88 2005/02/24-01:32:38.671 +VAR+INFO 11 : [HCT]
0CD8.0A88 2005/02/24-01:32:38.671 +VAR+INFO 11 : [HCT]
*******************************
0CD8.0A88 2005/02/24-01:32:38.687 +VAR+SEV2 11 : [HCT]Status=1805(70DH) Test
stopped with 5 minutes elapsed.(valdkit.cpp@8838)
0CD8.0A88 2005/02/24-01:32:38.687 +VAR+SEV2 12 : [HCT]Status=1805(70DH)
Tests did not complete … Exiting (dwState=6,Stopping)(valdkit.cpp@8852)
0CD8.0A88 2005/02/24-01:32:38.703 +VAR+INFO 13 : [HCT]Into QueryProcessInfo
for hWttProcess(XXXXX,spsrv.exe,3432)