Hi,
I was able to connect using 1394 finally!. Now I am facing a new issue.
When I set breakpoints, it successfully gets set. But after it breaks at the first break point, if I try to single step, it does for a few times and later, it suddenly fails and gives me some weird message “Unable to set breakpoint…etc…”?. After I get to this point, it fails even to “go(F5)” using the debugger. Hence I am forced to close the debugger, open a fresh instance to do a F5. But even in the new instance, I cannot single step. Any idea why this is happening?
Thanks in advance for your valuable answers
Shubha