Re: Translating a logical PCI device address to a phy sical slot numbe r

NTDEV
1

Then perhaps you are talking about an NT4 driver, as IoGetDeviceProperty is
certainly documented for post-NT4 ddks.

-----Original Message-----
From: Ruggiero Tom [mailto:xxxxx@siemens.com]
Sent: Tuesday, August 13, 2002 3:26 PM
To: NT Developers Interest List
Subject: [ntdev] Re: Translating a logical PCI device address
to a phy sical slot numbe r

Hi!,

thanks for your reply.

I’ve looked at the Windown NT DDK doc and this function is not avail.

Regards,

Tom

-----Original Message-----
From: Maxim S. Shatskih [mailto:xxxxx@storagecraft.com]
Sent: Tuesday, August 13, 2002 11:55 AM
To: NT Developers Interest List
Subject: [ntdev] Re: Translating a logical PCI device address
to a physical slot numbe r

> executed at system starts up time. One of the requirements is to
indicate to
> the user the physical slot number a particular defective PCI device
is in.

Can you call IoGetDeviceProperty on the PCI device’s devnode?

Max

You are currently subscribed to ntdev as:
xxxxx@siemens.com To unsubscribe send a blank email to
%%email.unsub%%

You are currently subscribed to ntdev as:
xxxxx@stratus.com To unsubscribe send a blank email to
%%email.unsub%%