RE: SoftIce causes page fault at boot time (Windows 2- 000)

Alberto,

I downloaded the latest video driver and the problem went away.

Thank you very much,

Don

-----Original Message-----
From: Don Doan [mailto:xxxxx@1pdc.com]
Sent: Wednesday, May 09, 2001 11:44 AM
To: NT Developers Interest List
Subject: [ntdev] RE: SoftIce causes page fault at boot time (Windows 2 000)

Alberto,

I am not running BoundsChecker. Here is the video info: ATI Technologies
Inc. RAGE 128 GL AGP
ati2draa.dll and ati2mpaa.sys File version 5.0.80. In the mean time I will
try new driver from ATI and possibly a different video card.

Thanks,

Don

-----Original Message-----
From: Moreira, Alberto [mailto:xxxxx@compuware.com]
Sent: Wednesday, May 09, 2001 7:39 AM
To: NT Developers Interest List
Subject: [ntdev] RE: SoftIce causes page fault at boot time (Windows 2000)

Don, do you have any more detail ? Are you running BoundsChecker ? Sometimes
what happens is that something triggers an event that BoundsChecker catches,
and SoftIce pops for that reason. If that’s the case, pressing the Escape
key while loading BoundsChecker at boot time would cure it.

Also, sometimes getting the latest video drivers from the supplier’s web
site helps. But if you tell us a bit more about this (which video board,
which rev of the driver, and so on) we’ll take it from this end and see
what’s going on.

Alberto.

-----Original Message-----
From: Don Doan [mailto:xxxxx@1pdc.com]
Sent: Tuesday, May 08, 2001 4:41 PM
To: NT Developers Interest List
Subject: [ntdev] SoftIce causes page fault at boot time (Windows 2000)
Has anyone seen this problem?

SoftIce, if configured to load at boot time, causes page fault at this
point:

NTICE: Successfully patch NT display driver = ati2draa.dll
Break due to page fault (0Eh). Fault = 0000h

Please help,

Don

You are currently subscribed to ntdev as: xxxxx@compuware.com
To unsubscribe send a blank email to leave-ntdev-$subst(‘Recip.MemberIDChar’)@lists.osr.com

You are currently subscribed to ntdev as: xxxxx@1pdc.com
To unsubscribe send a blank email to leave-ntdev-$subst(‘Recip.MemberIDChar’)@lists.osr.com

You are currently subscribed to ntdev as: xxxxx@1pdc.com
To unsubscribe send a blank email to leave-ntdev-$subst(‘Recip.MemberIDChar’)@lists.osr.com


You are currently subscribed to ntdev as: $subst(‘Recip.EmailAddr’)
To unsubscribe send a blank email to leave-ntdev-$subst(‘Recip.MemberIDChar’)@lists.osr.com