Hello,
I am trying to update a network driver on NT4, without any user
interaction. I cannot run the ncpa from the control panel.
I ran the ncpashel.inf using setup and I was only able to install the
device and copy the drivers, but was not able to bind the card and the
IP address.
I retrieved the IP address from the registry, but how do I set this back
to the new driver and bind it with the card?
Is there an inf that would help me bind the card and update the IP
address?? Or how else can I do this?
Any response will be helpful.
Regards
Sriram Narasimhan
You are currently subscribed to ntdev as: $subst(‘Recip.EmailAddr’)
To unsubscribe send a blank email to leave-ntdev-$subst(‘Recip.MemberIDChar’)@lists.osr.com