Newbie seeks HELP !!!

NTDEV
1

Hello All,

actually i have just downloaded NT4 ddk from microsofts site,
but i have NT version 6.0 ,so i want to know whether ddk for NT4.0
will work for NT 6 as well.
please also tell me how to configure the ddk in my system
after running its setup file.

Thanks ,
aashish

You are currently subscribed to ntdev as: $subst(‘Recip.EmailAddr’)
To unsubscribe send a blank email to leave-ntdev-$subst(‘Recip.MemberIDChar’)@lists.osr.com

2

Aashish,

You mean you have NT 4.0 Service Pack 6 (SP6).
(Thus, DDK for NT 4 is ok. :slight_smile:

Before trying to setup your system and configure your
development environment for yourself, reading this may
help you a bit:

http://www.hollistech.com/Resources/ddkbuild/ddkbuild.htm

Before you even *think* on configuring your environment
and actually began developing drivers, you should consider
reading a couple of good books on the subject. Also,
before posting doubts to this list you should try to find out
if your question has already been answered - go to the OSR
list manager at:

http://www.osr.com/listserver_main.htm

select ‘ntdev’, join in and search the info you’re looking for…

Miguel Monteiro
xxxxx@criticalsoftware.com

Critical Software, S.A. - http://www.criticalsoftware.com
111 North Market Street, 6th floor, San Jose, CA, USA, 95113
Tel: +1.408.9711231, Fax +1.408.9383929
R. Pedro Nunes, IPN, 3030-199 Coimbra, Portugal
Tel: +351.239.700945 - Fax: +351.239.700905

DISCLAIMER: This mail contents represent
my own personal opinions and do not, in any way,
represent the opinion or policy of Critical Software, S.A.

“Humour and love are God’s answers
to Human weaknesses” =:o)8

----- Original Message -----
From:
To: “NT Developers Interest List”
Sent: Tuesday, November 11, 1997 10:27 PM
Subject: [ntdev] Newbie seeks HELP !!!

Hello All,

actually i have just downloaded NT4 ddk from microsofts site,
but i have NT version 6.0 ,so i want to know whether ddk for NT4.0
will work for NT 6 as well.
please also tell me how to configure the ddk in my system
after running its setup file.

Thanks ,
aashish

—
You are currently subscribed to ntdev as: xxxxx@criticalsoftware.com
To unsubscribe send a blank email to leave-ntdev-$subst(‘Recip.MemberIDChar’)@lists.osr.com

—
You are currently subscribed to ntdev as: $subst(‘Recip.EmailAddr’)
To unsubscribe send a blank email to leave-ntdev-$subst(‘Recip.MemberIDChar’)@lists.osr.com