KNJN FPGA PCI board and add two UART IP

I had put 2 UART IP on KNJN DragonPCI board. My Question is that could I
use “serial” driver from the system (Windows XP)? I use DragonPCI WDM
driver to access PCI IO block and hook the IRQ. But how can I make XP
system find those two UART (Serial port)?

Thank
Lu

You have, in essence, added a bus to the system, one which is internal to
your device. Your UARTs are on that bus. Supply a bus driver. See the
KMDF toaster samples.

Jake Oshins
Windows Kernel Team

The message offers no warranties and confers no rights.

“ydlu” wrote in message news:xxxxx@ntdev…
I had put 2 UART IP on KNJN DragonPCI board. My Question is that could I use
“serial” driver from the system (Windows XP)? I use DragonPCI WDM driver to
access PCI IO block and hook the IRQ. But how can I make XP system find
those two UART (Serial port)?

Thank
Lu