USB Selective Suspend Test (XHCI) shpuld verify the selective suspend abilities of the USB device.
If run the test for a high speed or full speed USB 2 device the test fails with following error:
*USB device USB\VID_VVVV&PID_PPPP\S/N_F15D09953 with service xxxx did not power down or suspend. *
Please ensure the device is properly configured to power down when it is idle
The test works with earlier HLK 23H2. There the problem was filtered by filter 152598 v1. Actual this filter is available as v2. Content is the same but error will not be filtered by this.
Has anybody an idea what can be done to pass the test?