How can I run WinDbg with HCT 12.1? I’m chasing down a problem and the
debugger running but the HCT tests fail on the 1394 connection because
WinDbg has it. “Error: DevNode”
Gary G. Little
xxxxx@seagate.com wrote:
How can I run WinDbg with HCT 12.1? I’m chasing down a problem and the
debugger running but the HCT tests fail on the 1394 connection because
WinDbg has it. “Error: DevNode”
Disable the 1394 controller on the target. Windbg doesn’t care if the
device is turned on in device manager.
–
Tim Roberts, xxxxx@probo.com
Providenza & Boekelheide, Inc.
I tried that, however, HCT 12.1 still complains about a devnode problem.
Gary G. Little
-----Original Message-----
From: xxxxx@lists.osr.com
[mailto:xxxxx@lists.osr.com] On Behalf Of xxxxx@probo.com
Sent: Monday, January 09, 2006 2:46 PM
To: Kernel Debugging Interest List
Subject: Re: [windbg] HCT 12.1 and WinDbg
xxxxx@seagate.com wrote:
How can I run WinDbg with HCT 12.1? I’m chasing down a problem and the
debugger running but the HCT tests fail on the 1394 connection because
WinDbg has it. “Error: DevNode”
Disable the 1394 controller on the target. Windbg doesn’t care if the
device is turned on in device manager.
–
Tim Roberts, xxxxx@probo.com
Providenza & Boekelheide, Inc.
You are currently subscribed to windbg as: xxxxx@seagate.com
To unsubscribe send a blank email to xxxxx@lists.osr.com
xxxxx@seagate.com wrote:
I tried that, however, HCT 12.1 still complains about a devnode problem.
Yes, but at least it runs the test.
The problem I ran into is that I’d start a test run, then decide in the
middle that I wanted to hook up Windbg. HCT would detect that the 1394
controller state had changed, and refuse to continue the test. If you
disable before you start, that doesn’t happen.
–
Tim Roberts, xxxxx@probo.com
Providenza & Boekelheide, Inc.
Ok, thanks, I’ll give that a try.
Gary G. Little
-----Original Message-----
From: xxxxx@lists.osr.com
[mailto:xxxxx@lists.osr.com] On Behalf Of xxxxx@probo.com
Sent: Monday, January 09, 2006 3:37 PM
To: Kernel Debugging Interest List
Subject: Re: [windbg] HCT 12.1 and WinDbg
xxxxx@seagate.com wrote:
I tried that, however, HCT 12.1 still complains about a devnode problem.
Yes, but at least it runs the test.
The problem I ran into is that I’d start a test run, then decide in the
middle that I wanted to hook up Windbg. HCT would detect that the 1394
controller state had changed, and refuse to continue the test. If you
disable before you start, that doesn’t happen.
–
Tim Roberts, xxxxx@probo.com
Providenza & Boekelheide, Inc.
You are currently subscribed to windbg as: xxxxx@seagate.com
To unsubscribe send a blank email to xxxxx@lists.osr.com