All but one...

Ok, now I’ve run trough all but one of the unclassified tests, namely “USB-IF Test Certification ID Check”. The link on
http://msdn.microsoft.com/en-us/library/ee820106(v=MSDN.10).aspx points to no information, and I can’t find anything
relevant on compliance.usb.org :frowning:

Help?

TIA
/Rob

> Ok, now I’ve run trough all but one of the unclassified tests, namely "USB-

IF Test Certification ID Check". The link on
http://msdn.microsoft.com/en-us/library/ee820106(v=MSDN.10).aspx points to
no information, and I can’t find anything
relevant on compliance.usb.org :frowning:

Help?

Buried in the DTM help it says you input your USB-IF Test Certification ID by editing the test parameters. Meanwhile the requirement for the ID is not in force, yet. Until then you should find that the failing test result is filtered.

Regards,
Tim Green
Development Engineer
DisplayLink (UK) Limited
Registered in England No. 04811048

Tim Green skrev:

> Ok, now I’ve run trough all but one of the unclassified tests, namely “USB-
> IF Test Certification ID Check”. The link on
> http://msdn.microsoft.com/en-us/library/ee820106(v=MSDN.10).aspx points to
> no information, and I can’t find anything
> relevant on compliance.usb.org :frowning:
>
> Help?

Buried in the DTM help it says you input your USB-IF Test Certification ID by editing the test parameters. Meanwhile the requirement for the ID is not in force, yet. Until then you should find that the failing test result is filtered.

Yes, I have found the info on editing the parameter, but no info on whether this failure will fail my submission.

Thank you Tim, yet again :slight_smile:

Best regards,
/Rob