W2K: Hardware-ID for NDIS 5.0 NIC installation

I am trying to use W2K DDK samples: src\general\setup(Install, Remove,
Enable) to install an NDIS 5.0 NIC I have a perfrectly working INF. The
install sample reequires the INF and a Hardware-ID. I am puzzled. The DDK
documentation does not say that much on this. What is Hardware ID for an
NDIS 5.0 NIC card?

Thanks for any input,

xxxxx@mavion.com

Hello Fatih,

Thursday, June 15, 2000, 2:30:01 PM, you wrote:

FC> I am trying to use W2K DDK samples: src\general\setup(Install, Remove,
FC> Enable) to install an NDIS 5.0 NIC I have a perfrectly working INF. The
FC> install sample reequires the INF and a Hardware-ID. I am puzzled. The DDK
FC> documentation does not say that much on this. What is Hardware ID for an
FC> NDIS 5.0 NIC card?

FC> Thanks for any input,

FC> xxxxx@mavion.com

FC> —
FC> You are currently subscribed to ntdev as: xxxxx@ellisoft.de
FC> To unsubscribe send a blank email to $subst(‘Email.Unsub’)

PCMCIA card
USB adapter
PCI card
ISA PnP card

all this cards have a unique ID and your INF is started when you plug
in this type of cards.

me

Hi,

Can u send the inf file.This is because i feel that the Device ID which u
give inside the INF file may be the hardware ID. Please send the inf file
so that i can go through it.

Regards,
Santhosh

It may be the ClassGUID also.
Say for Eg: if you are developing a NDIS5.0 ether net adapter miniport
driver then it falls in a PCI category which has a specific class ID.
This is given in the documentation.
FOr PCI it is
ClassGUID = {4d36e972-e325-11ce-bfc1-08002be10318}

Regards,
Santhosh